![]() ![]() In between these two boxes is a row of tabs. ![]() Top is the horizon picture, the bottom shows data, probably all zeros since you're not connected. On the left side of the window are two boxes, one over the other. You can exit winSCP and power down your Solo.įor dataflash logs, open Mission Planner. Once you've transferred the files to your computer you are done with winSCP and your Solo. The dataflash logs have MUCH more data and can analyze problems with more specificity, but they are also more complicated. You can do the same for the "tlogs", which are the telemetry logs. Highlight all of those files and copy over to your desired computer folder. Scroll down and you will see files named "RECENT-*.BIN", where the * is a number. Look down the list for a folder named "logs." Open it. Double click again on the two dots and it will take you to the page with a lot of folders. Double click on the two dots and it will take you to the root folder. The right panel will probably be blank, with only two dots and the up arrow. Be careful not to delete or alter any folders or files in Solo! Take note the location of the folder to where you want to transfer your log files. The right side is the Solo, the left side is your computer. When connected, the winSCP is split in two panels, left and right. If you connect to the controller, you will not find the dataflash logs, only the telemetry logs (and a few other miscellaneous logs/files). Note, host name for the Solo is 10.1.1.10, and host name for the controller is 10.1.1.1. Solo Controller Host IP address (host name): 10.1.1.10.Connect to your Solo using the following: Factory default is "sololink", all lower case. Use whatever password you use to connect your phone/tablet. If it asks for a pin, select instead to use password. Same one you use to connect your phone/tablet to your Solo. ![]() Wait for the Solo to finish setting up, then connect your computer's wifi to the SSID "sololink", or whatever you named it. It's pretty straightforward and not that difficult.ĭownload and install Mission Planner: Installing Mission Planner - Mission Planner documentationĭownload and install winSCP: /download/winscp573setup.exe I wanted to post a way to download Solo telemetry and dataflash logs for analysis with Mission Planner, since there's a lot of confusion about this feature. ATTEMPT AT YOUR OWN RISK! I suggest following these instructions only if you're knowledgeable about computers and understand the risks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |